Amigos necesito que me ayuden a resolver esta gráfica :').

Explanation:

The difference of electrical potential between two points is called the potential difference.

It is also defined as the work done in the transfer of a unit quantity of electricity from one point to the other.

The SI unit of electric potential is volt. It is denoted by V.

Explanation:

Lets say you have a ball in your hand, you raise your hand to just above your head. Now, when you did that you created potential energy that is ready to be released. you drop the ball and the ball bounces a few times off the ground. Now lets say you got a ladder and doubled the ball's height doubling the energy now stored in the ball, when you drop it the ball should bounce much higher after hitting the ground as a result of more energy being released.

Hope this helped.

Answer:

7.5 J

Explanation:

To answer the question given above, we need to determine the energy that will bring about the speed of 1 m/s. This can be obtained as follow:

Mass (m) = 15 Kg

Velocity (v) = 1 m/s

Energy (E) =?

E = ½mv²

E = ½ × 15 × 1²

E = ½ × 15 × 1

E = ½ × 15

E = 7.5 J

Therefore, to change the speed to 1 m/s, the employee must do a work of 7.5 J.

Answer:

Significant

Explanation:

As the word suggests, significant figures or digits are numbers that are valid in measurement.

Answer:

SIGNIFICANT DIGITS

Explanation:

MARK ME BRAINLIEST PLZZZ

Answer:

a. V₂ = 6 V

b. 360 joules

c. The positive terminals of both the voltmeter and ammeter are connected to the positive terminal of the power source

Please see the attached drawing created with MS Visio

Explanation:

a. The voltmeter readings are;

V₁ = 12 V, V = 18 V

Given that the voltage reading, 'V', is the voltage reading across two loads with voltages, V₁ and V₂ connected in series, we have;

V = V₁ + V₂

V₂ = V - V₁

V₂ = 18 V - 12 V = 6 V

b. The reading of the ammeter, A, I = 0.5 A

The heat energy, Q  = I·V·t

Where;

t = The time = 1 minute (60 seconds)

Therefore, for the lamp L₁, where V = 12 V, we have;

Q₁ = 0.5 A × 12 V × 60 s = 360 Joules

The amount of electrical energy changed into heat and light in lamp L₁, Q₁ = 360 joules

c. The positive terminals of the voltmeter and ammeter are connected to the positive terminal of the power source

Please see attached drawing created with MS Visio

By Newton's second law, the net force acting on the crate parallel to the surface is

∑ F = mg sin(10°) - 800 N = ma

where m = 500 kg is the mass of the crate and a is the acceleration.

Solve for a :

a = ((500 kg) (9.80 m/s^2) sin(10°) - 800 N) / (500 kg)

a ≈ 0.102 m/s^2

Explanation:

area=length(m) ×breadth(m) . The unit of area is expressed in terms of fundamental units m^2.thus it is derived unit

Answer:

there it is fella atleast i tried

Answer:

The 80 mph car

Because the formula says 1/2 mass but for the velocity it is squared

Answer:

The untrue option is C: "More arrowheads on lines mean a brighter light"

Explanation:

Ray diagrams are used to show how the light behaves with things like mirrors or lenses. Where we only study how the direction of the light changes when it interacts with these objects.

The "light" is represented with arrows, where again, the only thing we care is the direction of the light, so the first statement is true, the arrowheads show the direction of the light, and only that.

The intensity of the light, in this context, has no effect on how light behaves, so there is not a necessity of representing the intensity of the light, thus, more arrowheads on lines do not mean a brighter light. It may only be used to represent changes in direction of the light.

Finally, we know that light travels in straight pats (the pats can be curved in some cases, like with large gravitational fields, but this is not the case of a ray diagram) so the lines that represent the light should always be straight, thus option B is also true.

The untrue option is C: "More arrowheads on lines mean a brighter light"

Answer:

Fan speed

Explanation:

because is the dependent variable

Answer:

Explanation:Gravitational force always acts on the ball in the downward direction, thus an acceleration due to gravity always point in the downward direction with a constant magnitude  10.6m/s  

Answer:

Jupiter and neptune

Explanation:

Answer: The answer is: D) as the moon revolves around earth, the different amounts of the sunlit side faces earth.

Explanation: I have my ways ;>

Have a great day!

-Sunny

Answer: The change in momentum is +20 kg.m/s

Explanation:

To calculate the final velocity of object, we use the first equation of motion:

[tex]v=u+at[/tex]

where,

v = final velocity

u = initial velocity = 0 m/s

a = acceleration = [tex]10m/s^2[/tex]

t = time = 0.5 s

Putting values in above equation, we get:

[tex]v=0+(10\times 0.5)\\\\v=5m/s[/tex]

Momentum is defined as the product of the mass and velocity of an object. It is given by the equation:

[tex]p=mv[/tex]

where,

p = momentum

m = mass of object = 2 kg

Let the upward velocity be positive and the downward velocity be negative

When the object is dropped, the velocity is downward

v = -5m/s

Initial momentum = [tex]2kg\times (-5m/s)=-10kg.m/s[/tex]

When the object is bounced back, the velocity is upward

v = +5m/s

Final momentum = [tex]2kg\times (+5m/s)=10kg.m/s[/tex]

Change in momentum = Final - Inital

Change in momentum = [10 - (-10)] = +20 kg.m/s

Hence, the change in momentum is +20 kg.m/s

Answer:

The tension in the thread is approximately 3.2103225 Newtons

Explanation:

The given parameters are;

The side length of the aluminum cube, s = 5 cm

The R.D. of aluminum = 2.7

The relative density of alcohol into which the aluminum cube is placed = 0.8

The volume of the aluminum cube, V = s³ = (5 cm)³ = 125 cm³

The mass of the aluminum cube, V = The volume of the cube

The mass of the aluminum cube, m = V × R.D. × Density of water

m₁ = 0.000125 × 2.7 × 970 = 0.327375 kg

The mass of the alcohol displaced, m₂ = 0.000125 × 0.8 × 970 = 0.097

The tension in the string, T = The apparent weight of the aluminum cube, Wₐ

∴ The tension in the thread, T = Wₐ = (m₁ - m₂) × g

Where;

g = The acceleration due to gravity ≈ 9.81 m/s²

∴ T ≈ (0.327375 - 0.000125) × 9.81 = 3.2103225

The tension in the thread, T ≈ 3.2103225 N.

Answer: i dont know

Explanation:

Answer:

[tex]{ \bf \: time \: of \: flight : s = 0} \\ { \tt \: s \: is \: displacement} \\ \\ s = ut + \frac{1}{2} a {t}^{2} \\ 0 = u \sin( \theta) t - \frac{1}{2} g {t}^{2} \\ u \sin( \theta)t = \frac{1}{2} g {t}^{2} \\2 u \sin( \theta) = gt \\ { \boxed{ \tt{formular : time \: of \: flight = \frac{2u \sin( \theta) }{g} }}} \\ t = \frac{2 \times 10 \times \sin(30 \degree) }{10} \\ { \green{ \boxed{ \tt{ \bf{answer : { \tt{time \: of \: flight =1 \: second }}}}}}} \\ \\ { \tt{becker \: jnr}}[/tex]

Answer:

power per square meter = 4.593 × 10^(6) W/m²

Wavelength of peak intensity = 9.67 × 10^(-7) m

Explanation:

From Stefan-Boltzmann law, total emitted power per square meter is given as;

P/A = eσT⁴

where;

P is power

A is surface area

σ = Stefan-Boltzmann constant = 5.67 × 10^(-8) W/m².k⁴

T = temperature of the body = 3000 K

e = emissivity of the substance (for ideal radiation, it has a value = 1)

Thus, Plugging in the relevant values we have;

P/A = 1 × 5.67 × 10^(-8) × (3000)^(4)

P/A = 4.593 × 10^(6) W/m²

Let's find the wavelength of peak intensity.

From wiens displacement law, we know that;

λ_m × T = b

where;

λ_m = maximum wavelength

T = Temperature

b is Wien's displacement constant = 2.9 × 10^(−3) m/K

thus;

λ_m = b/T = (2.9 × 10^(−3))/3000 = 9.67 × 10^(-7) m

Answer:

-50.6 kJ

Explanation:

The work done (W) on an object is given by:

W = (Fcosθ) * S

where F is the force, S is the displacement and θ is the angle between the force and displacement.

i) During the first trip riding east, S₁ = 2.93 km = 2930 m, F₁ = 8.65 N.

The displacement is due east and the force is due west, hence θ₁ = 180°. Therefore:

W₁ = (F₁ * cosθ₁)S₁ = (8,65 * cos(180))2930 = -25.3 kJ

ii) i) During the second trip riding west, S₂ = 2.93 km = 2930 m, F₂ = 8.65 N.

The displacement is due west and the force is due east, hence θ₂ = 180°. Therefore:

W₂ = (F₂ * cosθ₂)S₂ = (8,65 * cos(180))2930 = -25.3 kJ

work done by the resistive force during the round trip is:

W = W₁ + W₂ = -25.3 kJ + (-25.3 kJ) = -50.6 kJ

Answer:

Netball is a ball sport for two teams of seven players it's rules are published in print and online by the international netball federation Games are played on a rectangular court divided into thirds with a raised goal at coach short end

Explanation:

It will help you

Step-by-step explanation:

V = 2,143. 6 cm³ (rounded to one-decimal place) is the volume of a ball that has a radius of 8 cm.

Answer:

2143.57 cm^3

Explanation:

volume of a ball = 4/3 *π*r^3

= [tex]\frac{4}{3} *3.14 *8^{3}[/tex]

=[tex]\frac{4*3.14}{3} *512[/tex]

[tex]\frac{12.56}{3} *512[/tex]

=[tex]\frac{12.56*512}{3}[/tex]

=[tex]\frac{6430.72}{3}[/tex]

=2143.57

Answer:

B

Explanation:

Calculate the kinetic energy before and after they hold hands. Then, to find the change in kinetic energy simply subtract the final KE by initial KE.

Answer:

In a series circuit, how does the voltage supplied by the battery compare to the voltage on each load? The voltage of the battery is equal to the voltage of each load added together. ... The voltage across the two resistors must both have the same voltage of the battery.

Explanation:

mark me as BRAINLIEST

follow me

carry on learning

Answer:

The voltage of the battery is equal to the voltage of each load added together. The voltage across the two resistors must both have the same voltage of the battery.

>3

Answer:

two or more substances

Explanation:

A chemical reaction can't take place if there is only one substance

Answer:

A chemical reaction is the change that takes place when two

or more substances interact to form new substances.

Explanation:

Chemical reactions occur when chemical bonds between atoms are formed or broken. The substances that go into a chemical reaction are called the reactants, and the substances produced at the end of the reaction are known as the products.

Answer:

1.1 m/s

Explanation:

Applying,

v = u+at.............. Equation 1

Where v = final velocity, u = initial velocity, a = acceleration, t = time.

From the question,

Given: u = 0.3 ms, a = 0.4 m/s², t = 2 seconds

Substitute these values into equation 1

v = 0.3+0.4(2)

v = 0.3+0.8

v = 1.1 m/s

Hence the velocity at the end of 2 seconds is 1.1 m/s

Answer:

gadjgdasgdghgsdgd

Explanation:sorry need answer

Answer:

V * t = cm/sec * sec = cm

V * t should give distance as a result  -  

The other three fit the fundamental equations