HELP PLEASE : )
IT'S SCIENCE

The tension in the string pulling the box is most nearly 17 N.

The given parameters;

The tension on the string is calculated by applying Newton's second law of motion as follows.

[tex]\Sigma F = ma[/tex]

at constant speed, acceleration, a, = 0

[tex]\Sigma F = 0\\\\T_x - \mu F_n = 0\\\\Tcos(\theta) - \mu F_n = 0\\\\Tcos(\theta)= \mu F_n\\\\T = \frac{\mu F_n}{cos(\theta)} \\\\T = \frac{0.3 \times 5 \times 9.8}{cos(30)} \\\\T = 16.97 \ N\\\\T \approx 17 \ N[/tex]

Thus, the tension in the string pulling the box is most nearly 17 N.

Learn more here:https://brainly.com/question/21040480

Answer:

R=v2isin2Big R

=v I 2 sin 2 B I g

The minimum force required to start this block moving is 370 N.

The given parameters;

The minimum force required to start this block moving is calculated as follows;

[tex]F= \mu_s F_n[/tex]

where;

[tex]F_n[/tex] is the normal force on the block which is equal to the weight of the block

[tex]F= \mu_s F_n \\\\F= \mu_s W\\\\F = 0.74 \times 500 \\\\F= 370 \ N[/tex]

Thus, the minimum force required to start this block moving is 370 N.

Learn more here: https://brainly.com/question/13877320

Answer:

like 23 or something

Explanation:

Answer:

It is a physical

Explanation:

Answer:

Explanation:

Answer:

"rings" - viewed from a distance, Saturn appears to be surrounded by rings

Answer:

D. F= 17.5 N left

Explanation:

I just took the quiz and got it correct!

Answer:

2.45 g/mL

Explanation:

(assuming that the original volume was 20 mL and not L)

Since you know the amount of water in the cylinder before and after you placed the rock in, you can subtract them to get the volume of the rock itself. [tex]30.2-20=10.2[/tex] mL.

To get the rock's density, use the equation [tex]d=\frac{m}{v}[/tex], where m is mass and v is volume.

[tex]d=\frac{25 g}{10.2mL}\\\\d=2.45 g/mL[/tex]

Answer:

increase

decrease

Explanation:

using formula

Vt=mg/6πηr

so if m increases V increases

r is the denominator so if r increases V decreases

Answer:

Balloon that an ocean diver takes to a pressure of 202 k Pa will get reduced in size that is the volume of the balloon will get reduced

Explanation:

An energy storage device composed of electrochemical cells is referred to as: battery.

A power source can be defined as a source of electrical energy that is used to power all electronic devices.

Generally, a power source can be classified into two (2) main categories and these include:

A battery refers to an energy storage device that comprises electrochemical cells and it serve as a source of direct current (DC). Also, sometimes a battery can be recharged when its electrochemical cells are still active.

Read more on battery here: https://brainly.com/question/4922532

Answer:

Battery is an electrical energy storage device consisting of one or more electrochemical cells with external connections that provide power to electrical devices such as flashlights, smartphones, and electric cars.

Answer:

PLEASE MAARK ME BRAINLEST!!!

Explanation:

The particles of the medium just vibrate in place. As they vibrate, they pass the energy of the disturbance to the particles next to them, which pass the energy to the particles next to them, and so on.

Answer:

According to the law of conservation of mass, the mass of the products in a chemical reaction must equal the mass of the reactants. The law of conservation of mass is useful for a number of calculations and can be used to solve for unknown masses, such the amount of gas consumed or produced during a reaction.

Explanation:

<3

Answer:

the bottom one is wollsiegel

Answer:

it look the same just to tell you

Answer:Pulley , Wheel and axle , Screw , wedge , Incline

Explanation:

Answer: below .

Explanation:

Pulley , Wheel , axle , Screw , wedge , Incline

HOPE IT HELPS YOU .PLEASE GIVE BRAINLIEST .THANKS .

Please find attached photograph for your answer.

Hope it helps.

Do comment if you have any query.

Answer:

less' shorter

Explanation:

be cuase science

Answer:

The answer is D.

Explanation:

When waves are closer together, the distance between them is less, therefore the waves have longer wavelength.

Explanation:

given

m=3500kg,h=4.0m,v=12m/s

ke=½mv²

½×3500×12²=3500×144÷2

=252,000j or 252j

Answer:

It can cause death by asphyxiation in minutes or a gas/air embolism. This can cause the blood vessels to rupture and cause hemorrhage

Explanation:

Inhaling helium from a pure helium pressurized tank can cause something called an 'air embolism'. This is eventually a bubble that was trapped in a blood vessel, and therefor blocks it. The blood vessels can then rupture and hemorrhage.

Short answer: The results of breathing in 100% pure helium is asphyxiation, which eventually causes death.

I hope this helps! (If this was a question which had multiple choice answers, feel free to post them in the comment section and I would be more than happy to give you a direct answer to the test.)

When the experimental measurements diverge at very low values of the voltages. When the ratio of current to saturated current is very small. That is, i/I less than or equal to 1/100. When there is a finite current at Voltage

V = 0

Diffusion will have influence on current - voltage curve in the working electrode which is ionization detector.

The estimation under set of conditions that is possible, despite the spherical shape of the working electrode, to use linear diffusion equations to theoretically predict the current vs voltage curve expected in this experiment will be:

Where

i = electric current

I = saturated current

V = voltage supplied

The curve expected will therefore give exponential curve from positive to negative domain because of the diffusion of ions from different directions

Learn more here: https://brainly.com/question/23985719

Answer:When carbon atom tends to form single bonds then its hybridization is , when carbon atom tends to form double bond then its hybridization is  and when a carbon atom is attached to a triple bond or with two double bonds then its hydridization is sp.

For example, in HCN molecule there is a triple existing between the carbon and nitrogen atom.

So, hybridization of carbon in this molecules is sp. Moreover, nitrogen atom is also attached via triple bond and it also has a lone pair of electrons. Hence, the hybridization of nitrogen atom is also sp.

Thus, we can conclude that s and p type of orbitals overlap to form the sigma bond between C and N in H−C≡N:

Explanation:

Using the principle of dimensional analysis, the representation of Pressure would be [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]

Pressure is related to Force, Volume and Density thus :

[tex] Pressure, P = F^{a}V^{b}D^{c}[/tex]

Using dimensional analysis :

Substituting the dimension into the relation :

[tex] ML^{-1}T^{-2}= [MLT¯²]^{a} [L³]^{b} [ML¯³]^{c} [/tex]

[tex] ML^{-1}T^{-2} = M^{a+c}L^{a+3b-3c}T^{-2a} [/tex]

Equating the power ;

a + c = 1 - - - (1)

a + 3b - 3c = - 1 - - - (2)

-2a = - 2

a = - 2/-2

a = 1

From (1)

1 + c = 1

c = 1 - 1 = 0

c = 0

From (2) :

1 + 3b - 3(0) = - 1

1 + 3b = - 1

3b = - 2

b = - 2/3

Hence, [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]

Learn more :https://brainly.com/question/25690057

The representation of pressure is:

[tex]P=FV^{-\frac{2}{3} }[/tex]

Given that:

Force F, volume V and density D are taken as fundamental quantities, hence pressure P is:

[tex]P=F^aV^bD^c\\\\(ML^{-1}T^{-2})=(MLT^{-2})^a(L^3)^b(ML^{-3})^c\\\\\\(ML^{-1}T^{-2})=(M)^{a+c}(L)^{a+3b-3c}(T)^{-2a}[/tex]

Hence:-

2 = -2a

a = 1

a + c = 1

1 + c = 1

c = 0

a + 3b - 3c = -1

1 + 3b - 3(0) = -1

3b = -2b = -2/3

Hence the representation of pressure is:

[tex]P=FV^{\frac{-2}{3} }D^{0}\\\\P=FV^{\frac{-2}{3} }[/tex]

Find out more at: https://brainly.com/question/24894056

Explanation:

Light travels fastest through air

Answer:

try through air

Explanation:

Given,

Force = 10,000 N

Distance = 30 m

Time = 40 s

Work done = force × distance

Work = 10,000 × 30

Work = 300,000 J

______

꧁✿ ᴿᴬᴵᴺᴮᴼᵂˢᴬᴸᵀ2222 ✬꧂

The work done on the object is equal to the power it experiences which is equal to 735 watts.

Work done is defined as the product of force applied and the distance over which the force is applied on the object. Work is done on an object when a force is applied to an object and the object is moved through a particular distance.

The time rate of doing work is called as power, which is designated by the symbol P. It is measured in the units of watts, where one watt is equal to one joule energy applied per second time.

Work done on an object is equal to the force (F) multiplied by the distance d in the direction of the force. Where, time interval is Δt.

P = W/Δt = F × d/Δt = m × g × h/Δt = 100 × 9.8 × 30 / 40

Power = 735 watts

The power of the object is 735 watts.

Learn more about Work done here:

https://brainly.com/question/13662169

#SPJ2

Answer: talking about others

   Liquids are pourable because they do not maintain a "solid" structure as solids do, but still have structure, unlike gasses. Why is this? The forces between liquid particles are weaker than the forces between solid particles. The particles are further apart and move around more easily.

Have a nice day!

     I hope this is what you are looking for, but if not - comment! I will edit and update my answer accordingly. (ノ^∇^)

- Heather