How is it difficult to perform electrostatic experiments on humid days​

Answer:

Well Albert Einstein is more smarter PERIOD

Explanation:

Answer:

the answer is c) 25.1 feet/second

Explanation:

because the blood droplets can not increase speed past terminal velocity 100.

The terminal velocity of blood is 25.1 ft/s in air. So, option C is correct.

Terminal velocity is defined as the maximum velocity to which a freely falling drop can accelerate.

Here,

When a drop of blood is observed, it can be found that due to the effect of gravity, the velocity of the freely falling blood drop increases. So, it moves with increasing velocity, which is due to the influence of acceleration due to gravity. During the free fall of blood drop, there are resistive forces in air that opposes the motion or tries to reduce the velocity of the blood drop. The friction in air affects the freely falling blood drop and the blood drop tends to reduce its velocity and reaches a maximum of velocity after which it cannot accelerate, which is due to the frictional force in air. This maximum velocity is called terminal velocity. The terminal velocity of blood is 25.1 feet/second.

Hence,

The terminal velocity of blood is 25.1 ft/s in air.

To learn more about terminal velocity, click:

https://brainly.com/question/13655133

#SPJ2

Answer: Option b.

Explanation:

We know:

Wavelength = 632.8 nm

Fluence = 4.5*10^20 photon/s

The energy of a single photon of wavelength λ is:

E = (h*c)/λ

where:

h = 6.6*10^(-34) J*s

c = 3*10^8 m/s

And we should rewrite the wave length in meters, so:

λ = 632.8 nm = 632.8*10^(-9) m

replacing these in the energy equation, we get:

E = (6.6*10^(-34)J*s)*(3*10^8 m/s)/(632.8*10^(-9) m) = 3.13*10^(-19) J

So each one of the  4.5x10^20 photon that flow each second have this energy, then the power is:

P = (3.13*10^(-19) J)*(4.5*10^20 /s) = 140.85 J/s

and 1 W = 140.85 J/S

Then the power is:

P = 140.85 W

Then the correct answer is the option b, where the units are a little bit different than mine because I used really simplified values for c and h.

Answer:

You must label the horizontal axis with the names of the airlines and the vertical axis with the number of flights. The title must clearly state what data the bar chart is showing. With larger numbers, your scale may not go up by one.

Answer:

You must label the horizontal axis with the names of the airlines and the vertical axis with the number of flights. The title must clearly state what data the bar chart is showing. With larger numbers, your scale may not go up by one.

Explanation:

can you help me please? https://brainly.com/question/22653337

Answer:

rocks are vertical.

Explanation:

I'm so sorry if I'm wrong this is what I think

Answer:

3.9 × 10^7 J

Explanation:

Given that a tank is is half full of oil that has a density of 900 kg/m3. Find the work W required to pump the oil out of the spout. (Use 9.8 m/s2 for g. Assume r = 15 m and h = 5 m.) W = 1.59 J

Solution

Since the tank is half full, the height = 2.5m

Pressure = density × gravity × height

Pressure = 900 × 9.8 × 2.5

Pressure = 22050 Pascal

The cross sectional area of the pump will be area of a circle.

A = πr^2

A = π × 15^2

A = 706.858 m^2

Using the formula

Density = mass/volume

Mass = density × volume

Mass = 900 × 706.86 × 2.5

Mass = 1590.435

Energy = mgh

Energy = 1590.435 × 9.8 × 2.5

Energy = 38965657.8 J

Since the work done = energy

Therefore, the work done = 3.9 × 10^7 J

Answer: 0.33 m/s^2

Explanation:

The acceleration of Odysseus' ship as it moves across the water from Troy to Ithaca is 0.33m/s²

Given the data in the question;

To determine the acceleration of the ship, We the equation from Newton's Second Law of Motion:

[tex]F = m\ *\ a[/tex]

Where F is the force, m is the mass and a is the acceleration

Lets make acceleration ''a'', the subject of the formula

[tex]a = \frac{F}{m}[/tex]

Now, we substitute our given values into the equation

[tex]a = \frac{300000N}{900000kg}[/tex]

We know that, A newton is defined as [tex]1 kg.m/s^2[/tex]

[tex]a = \frac{300000 kg.m/s^2}{900000kg} \\\\a = 0.33m/s^2[/tex]

Therefore, the acceleration of Odysseus' ship as it moves across the water from Troy to Ithaca is 0.33m/s²

Learn more, https://brainly.com/question/2842540

Answer:

one of the mjor effects of heat transfer is temperature change

Explanation:

simple answer

Answer:

Homeostasis is the ability of the body to maintain balance inside the cells, even as the surrounding environment changes

The correct option is (1)Homeostasis is the ability of the body to change to match the surrounding environment.

Homeostasis is the ability of an organism or system to maintain a stable internal environment, despite changes in external conditions. This is achieved through a variety of physiological and behavioral mechanisms that help regulate various bodily functions such as temperature, blood sugar levels, hydration, and oxygen levels.

The process of homeostasis involves the detection of changes in the internal or external environment, followed by a response that helps restore the optimal conditions. For example, if the body's temperature rises above normal levels, the brain triggers sweat production to cool down the body.

Homeostasis is essential for the proper functioning of cells, tissues, organs, and the entire organism. It helps maintain a balance between various bodily functions and ensures that cells have the necessary conditions to carry out their functions. Without homeostasis, cells would be unable to survive and carry out the functions required for life.

Hence the correct statement about homeostasis is, Homeostasis is the ability of the body to change to match the surrounding environment.

To learn more about Homeostasis click:

https://brainly.com/question/3888340

#SPJ3

Answer:

20 seconds

Explanation:

Answer:

true

Explanation:

because I tride it

Answer:

nas wr hdrtuendnetyje because

Explanation:

Answer:

reviewing the different answers, the correct one is d

Explanation:

In the experiment to determine the resistivity of the wires, the student should use the relationship

         R = ρ L / A

         ρ = R A/L

in the statement they indicate that the difference that potential and current are measured, calculating the resistances from Ohm's law

         V = i R

          R = V / i

As resistivity is a property of the material that depends on the temperature, great care must be taken that the resistors do not change the temperature during the experiment, as this alters the resistivity value.

When reviewing the different answers, the correct one is d

Answer:

D

Explanation:

You are boiling more grams for more time because the more water the longer it takes which requires more calories to burn it.

Answer:

Venus

Explanation:

Answer:

they will move away from each other

Answer:

(a) T = 18309.63 N = 18.31 KN

(b) T = 16314.03 N = 16.314 KN

Explanation:

(a)

The tension in an elevator while moving upward with some acceleration is given by the following formula:

[tex]T = m(g+a)\\[/tex]

where,

T = Tension = ?

m = mass = 1663 kg

g = acceleration due to gravity = 9.81 m/s²

a = acceleration of elevator = 1.2 m/s²

Therefore,

[tex]T = (1663\ kg)(9.81\ m/s^2 + 1.2\ m/s^2)\\[/tex]

T = 18309.63 N = 18.31 KN

(b)

Constant velocity means no acceleration. So, in that case, the tension will be equal to the weight of the elevator:

[tex]T = mg\\T = (1663\ kg)(9.81\ m/s^2)\\[/tex]

T = 16314.03 N = 16.314 KN

Answer:

b

Explanation:

Answer:

The table shows the height y (in thousands of feet) of an unmanned aerial vehicle (UAV) x minutes after it begins its descent from cruising altitude. Minutes, x Height (thousands of feet), y 0,62 5,58 10,54 15,50

Answer:

a. The current is flowing from South to North. So, the current flows in the North direction

b. West

Explanation:

a. A compass needle placed above the wire points with its north pole toward the east. In What direction is the current flowing?

Using Maxwell's corkscrew rule, with the thumb of the right hand pointing in the direction of the current and the closed fingers pointing in the direction of the magnetic field.

Since the compass is placed above the wire and points east, the direction of the magnetic field at that point is east.

Since the magnetic field is tangential to the circular path around the wire, to produce an eastward magnetic field above the wire, the current must go from South to North. So, the current flows in the North direction.

b. If a compass is put underneath the wire, in which direction will the compass needle point?

If the compass is put underneath the wire, using Maxwell's corkscrew rule, since the current points northward, and the magnetic field is tangential to the circular path around the wire, the magnetic field below the wire points west.

So, the direction of the compass needle when the compass is put beneath the wire is west.

Answer:

Look it up

Explanation:

We need to use 6 red circles as well as 8 blue circles to represent the 6 protons and 8 neutrons in the nucleus, after which we need to place 6 yellow circles around the nucleus to represent the 6 electrons in the atom. is required. Thus, the correct option is A.

To make an accurate model of a carbon-14 atom, we need to follow the steps that represent the correct number of protons, neutrons, and electrons in a carbon-14 atom.

Carbon-14 has 6 protons and 8 neutrons, so we will use a total of 6 red and 8 blue circles around the nucleus which also has 6 electrons, so we need to put 6 yellow circles around the nucleus.

The correct steps to follow to create a model of a Carbon-14 atom are:

Step 1:  Use 6 red circles for the nucleus of the atom

Step 4: Add 8 blue circles to the nucleus of the atom

Step 6:  Place 6 yellow circles around the nucleus of the atom

Thus, the correct option is A.

Learn more about Carbon-14 atom, here:

brainly.com/question/30727793

#SPJ2

Answer:

273.15

Explanation:

So that's three over two times 1.38 times ten to the minus twenty-three joules per Kelvin, times 5500 degrees Celsius, the surface of the sun converted into Kelvin by adding 273.15. This works out to 1.20 times ten to the minus nineteen joules. So that's the average kinetic energy of hydrogen atoms.

Answer:

      v’ =( [tex]\frac{1}{1+ \frac{M}{m} }[/tex]  )  v

we see that the greater the difference, the more the sled slows down.

friction force

Explanation:

When the man pushes the sled he does work and the sled acquires a speed and as long as it is supplied with an energy equal to the work of the chipping force with the snow, the speed is maintained.

When he jumps on the sled, a collision occurs and the initial moment

             p₀ = mv

is increased by the increase in mass

             m_f= (m + M_{man} ) v '

In this case there is no longer any external force applied and the only external force is friction, which causes the sled to stop, even when it is small, but the significant reduction in speed is due to the increase in masses.

            p₀ = p_f

            mv = (m + M_{man}) v '

            v ’=  [tex]\frac{m}{m+M}[/tex] v

            v’ =( [tex]\frac{1}{1+ \frac{M}{m} }[/tex]  )  v

Therefore, we see that the greater the difference, the more the sled slows down.

The only forces that act on the sled with the man are the friction that is responsible for the decrease in speed and weight with the normal

Answer:

A) Energy is dissipated into heat and sound energy due to Friction

B) The energy goes into heat and sound energy due to friction again, otherwise the cart would accelerate due to an unbalanced force. Therefore, we know there's friction, and the friction causes energy loss.

Answer:

W = 6.5 W

Explanation:

Work is defined by

         W = F . d

          W = f d cos tea

where the point represents the scaled product and the bold letters indicate vectors

they ask us the work of the friction force

we write the translational equilibrium equation

y Axis

                  N -W = 0

                  N = mg

x axis

                  F - fr = 0

                  F = fr

the formula for the friction force is

                  fr = μ N

we substitute

                  fr = μ m g

we substitute in the equation of work

           W = fr d cos θ

            W = μ m g d cos θ

let's calculate

            W = 0.500 1.10 9.8   Σ d_i  cos θ_i

            W = 5.39 d cos tea

we have two displacement

the first on one side of the box, suppose that side is on the y-axis, therefore the angle between the displacement and the friction force is 70º

and there is a second displacement in the x axis, in this case the angle between the friction force and the displacement is 30º

therefore the total workload is the sum of those work

            W = 5.39 (1 cos 70 + 1 cos 30)

             W = 5.39 (0.342 + 0.866)

             W = 6.5 W

Answer:

100

Explanation:

since the two at the left side is pulling with a force of 70 and 60 which equals to 130 for the rope to be in equilibrium, those at the left must also pull with same force. Which makes it 130-30=100N

Answer:

The sound is perceived as louder if the amplitude increases, and softer if the amplitude decreases. ... As the amplitude of the sound wave increases, the intensity of the sound increases. Sounds with higher intensities are perceived to be louder.

Answer:

The other force is the weight of the student.

Explanation:

With respect to Newton's third law of motion, for the student to sit and balance on the chair, there must be two equal and opposite forces involved. The student applies his/ her weight on the chair which acts downwards, while the chair applies an equal but opposite force to the weight of the student.

The force applied by the chair on the student's body is counter balanced by the student's weight. Note that, if the weight of the student is greater than the opposing force from the chair, the chair would collapse.