Answer:
F, Si, Cl
Explanation:
The flow of the electronegativity is up and far left. Therefore, the highest amount is in the far left and up because that is the trend. You can look up a graph on google showing the trend.
What was Pangea and when did it form?
Answer:
Pangaea or Pangea ( /pænˈdʒiːə/) was a supercontinent that existed during the late Paleozoic and early Mesozoic eras. It assembled from earlier continental units approximately 335 million years ago, and it began to break apart about 175 million years ago.
Explanation:
how many joules are needed to heat 20.0 g of Au from 10 C to 50 C
Answer:
Its actually Q = 103.2 J
Explanation:
Mark is in charge of making change at his family's garage sale on a hot summer day. He runs low on change and brings out a jar of pennies from the house. He keeps the lid off of the jar. Later in the day, he notices that the pennies are hot. Which statement best explains what happened?\
Answer:
This question is incomplete
Explanation:
The question is incomplete without the options. However, when a metal (in this case what the pennies are made of) is left in direct contact with the heat from the sun, it conducts this heat and becomes hot. This process is called thermal conduction. The thermal energy is readily accepted by the material in which the pennies are made of thereby increasing the thermal energy of the penny coin which then makes the pennies hot after being left under the sun.
A physical change is easier / more difficult to reverse than a chemical change.
Answer:
the answer is that a physical change is easier to reverse then a chemical change.
Explanation: In order for a physical change to take place it's easier to just undo what happened then if it was a chemical change because in order for very few chemical changes to reverse to it's original substance you would need another chemical change.
Where is the youngest rock in the Atlantic Ocean found?
Answer:
oceanic ridge
The youngest rocks on the ocean floor are located at the oceanic ridge, an underwater mountain range formed from the spreading of tectonic plates in.
Explanation:
1234567891011121314151617181920
ANSWER ASAP PLEASE!!
What determines how many of each ion is required for an ionic compounds?
please do not look up on google!!!!
Each ion has a single charge, one positive and one negative, so we need only one ion of each to balance the overall charge. When writing the ionic formula, we follow two additional conventions: (1) write the formula for the cation first and the formula for the anion next, but (2) do not write the charges on the ions.
Rubbing alcohol or isopropanol can be described by the chemical formula C3H7OH. One milliliter of isopropanol has a mass of 0.76 g, so its density is 0.76 g/mL. Isopropanol is often used as a cleaner or a disinfectant and evaporates when placed on warm objects. However, caution must be taken when using isopropanol, because it is also highly flammable. Which of the following is a chemical property of isopropanol?
A. One mL of isopropanol has a mass of 0.76 g.
B. Isopropanol has a density of 0.76 g/mL.
C. Isopropanol evaporates when placed on a warm object.
D. Isopropanol is flammable.
A chemical property of isopropanol : D. Isopropanol is flammable.
Further explanationThere are changes that occur in the mater: physical changes and chemical changes
Classification uses the principle of the initial and final state of the substance.
Physical changes do not form new substances, so the properties of the particles remain the same.(size,volume,shape)
Example : boiling and freezing, just change its phase form from liquid to gas or from liquid to solid
Chemical changes/reaction form new substances(products) that are different from the initial substances(reactants)
Example : toxic, corroded
So :
the physical properties of isopropanol :mass, density, evaporation
the chemical properties of isopropanol :highly flammable
Answer:
D. Isopropanol is flammable.
Explanation:
Mass, volume, temperature, phase of matter, color, texture, density, and hardness are all examples of physical properties. However, flammability is an example of a chemical property.
Chemical properties describe an object's potential to change its chemical composition. These properties depend on the types of atoms found in the object and the arrangement of those atoms (and their subatomic particles).
What is the relationship between the latitude and hours of daylight
Answer:
The tilt of the Earth's axis also defines the length of daylight.Daylight hours are shortest in each hemisphere winter. Between summer and winter
solistice the number of daylight hours decreases and the rate of decrease is larger the higher the latitude.The fewer sunlight hours the colder nights.
What explains the structure of metals and delocalized electrons?
A. the unit cell model
B. the geometric shape model
C. the covalent bond model
D. the electron sea model
28 grams of H2 are produced from an experiment. How much volume would they displace at STP?
Answer: 0.86 "L" 1 "mol" of "Zn" has mass of 65.39 "g". The amount of "Zn" is frac{2.5 "g"}{65.39 "g/mol"} = 0.038 "mol". The amount of "H"_2 produced is the same as the amount of "Zn" consumed (0.038 "mol").
Explanation:
What kinds of paintings did Winslow Homer make
Identify the chemical formula of ammonia.
Answer:
The chemical formula for ammonia is NH3
Explanation:
Nitrogen trihydride
1. A cube of wood having an edge length of 15.3 cm has a mass of 2800 grams. What is the
density of the wood in g/cm3?
Answer:
a cube wood is mass ig haha sorry bby :(
Explanation:
Considering the principles of KMT, which scenario would result in an increase of particles effective collisions at STP None of the above None of the above In a balloon In a balloon A container with large volume A container with large volume A container with small volume
Answer:
A container with small volume
Explanation:
The question is obviously incomplete because the image attachments are missing.
However, it is necessary to note that, the effective collisions depends on the volume of the gas.
The lesser the gas volume, the greater the effective collision between particles at STP.
Hence from the KMT, the scenario having the least volume of gas will have the greatest magnitude of effective collisions.
You have a solution of water and pure ethanol. The boiling point of water is 100 degrees Celsius and the boiling point of pure ethanol is 78 degrees Celsius. A. What process would you would use to separate this solution? Describe, in detail, how this process works.
Answer:
Distillation
Explanation:
A solution of water and ethanol are miscible. Hence, they can only be separated by a process known as distillation. Distillation is the process in which two or more constituents in a mixture are separated based on there difference in boiling points. The mixture is subjected to high heat and the one with the least boiling point distills/evaporates out first followed by the next least boiling point.
From the explanation above, it can be deduced that ethanol (with boiling point of 78°) will be distilled out while water remains in the boiling tube or container.
The heat required to raise the temperature of 12g of water from 16 C to 21 C is:
a) 60 J
b) 60 cal
c) 50 cal
d) 50 J
Answer:
The correct option is;
b) 60 cal
Explanation:
The mass of the given water, m = 12 g
The initial temperature of he given water = 16°C
The final temperature of the given water = 21°C
The specific heat capacity of water, c = 4.184 J/(g·°C) = 1 cal/(g·°C)
The amount of heat, ΔQ, required = Mass × Specific heat capacity × Change in temperature
ΔQ = 12 × 4.184 × (21 - 16) = 251.04 J
Similarly, we have;
ΔQ = 12 g × 1 cal/(g·°C) × (21 - 16)°C = 60 cal
The amount of heat required = 60 cal.
Which isotope of sulfur is the most naturally abundant
Answer:
The Isotope of sulfur.
32S 94.99% stable.
33S 0.75% Stable.
Explanation:
what does CER mean for science?
Explanation:
Claim, Evidence, Reasoning (CER) model, an explanation consists of: A claim that answers the question. Evidence from students' data. Reasoning that involves a rule or scientific principle that describes why the evidence supports the claim.
Joyce poured 200 milliliters (mL) of water into a beaker, placed a thermometer in it, and heated it until it started to boil. She recorded a temperature of 100 degrees Celsius (°C) when it started to boil. She repeated the process with 400 mL of water. What would be the temperature when this second sample started to boil?
Answer:
100°C
Explanation:
The boiling point of water is 100°C and the difference is when will the water start boiling.
challenges we will face terraforming Mars
The ion X2- belongs to an element in Group
Answer:
ion X²- an element in group VI A.
500 gram of flour added with 1L of water anong lalagyan o bottle magkakasya ang 500gram of flour ang 1L of water
Answer:
it will become a bread
Explanation:
net Mass will become 1.5 liter
The first chemists, philosophers like, Aristotle were from which country?
Answer:
greece
Explanation:
aristole was particularly from stagria, greece. but most early philosophers are from greece
What is the difference between Chemistry and Alchemy?
Answer:
The difference between alchemy and modern chemistry is alchemy is based on a mystic, supernatural view of reality, whereas chemistry assumes reality is basically natural.
Explanation:
hope this helps!
if faucet drips 5 mL of water each minute, what is the volume of water dripped at the end of five minutes?
5 mL
25 mL
5 m³
25 m³
I apologize for being dumb XD
What factors are included on a phase diagram?
O A. Temperature and pressure
O B. Pressure and volume
O C. Mass and volume
O D. Heat and kinetic energy
Answer:
A. Temperature and pressure
Explanation:
The factors included in a phase diagram are the temperature and pressure conditions.
A phase diagram is a combined plot of three curves all in equilibrium;
Solid- liquid, liquid -gas, and solid -gas plots
On the vertical axis, we usually have the pressureOn the horizontal axis is where the temperature is represented. Most phase diagrams are used in chemistry and mineralogy to show areas in which different phases can exist at equilibrium.The factors included on a phase diagram are temperature and pressure and the correct option is option A.
A phase diagram is a graphical representation that shows the different phases of a substance (solid, liquid, and gas) as a function of temperature and pressure. It provides valuable information about the conditions at which different phases can exist and the boundaries between them.
The temperature is typically plotted on the horizontal axis, while the pressure is plotted on the vertical axis.
By examining a phase diagram, one can determine the melting point, boiling point, and critical point of a substance, as well as the regions of stability for each phase. Additionally, phase diagrams can reveal the existence of phase transitions such as melting, boiling, and sublimation.
Thus, the ideal selection is option A.
Learn more about Phase diagram, here:
https://brainly.com/question/34149833
#SPJ6
4. What happens to the sun's rays as they radiate towards the earth?
Answer:
Most of the solar radiation is absorbed by the atmosphere and much of what reaches the earth's surface is radiated back into the atmosphere to become heat energy.
Explanation:
What is force and motion
Answer:
In physics, a force is any interaction that, when unopposed, will change the motion of an object. A force can cause an object with mass to change its velocity (which includes beginning moving from a state of rest), i.e., to accelerate. Force can also be described intuitively as a push or a pull.
lol
Please help
The charge of o monatomic ion is its oxidation number.
O True
O False
O Neither
Having a widow's peak like Wentworth
Miller is dominant.
Not having a widow's peak, like Rihanna, is
recessive.
10) If Wentworth Miller is Aa, and he and Rihanna had children, what are the possible
phenotypes and genotypes of their children?
Answer:
Aa 50% Widow's peak, aa 50% no Widow's peak
Explanation:
In the crossing over the phenotypes of their children, 50% are widow's peak (aa), while 50% are not widow's peak (Aa) because the widow's peak genes only show trait when it is in recessive condition.
What is a recessive condition?An inheritance pattern known as autosomal recessive inheritance allows a genetic disease or characteristic to be transferred from parent to offspring.
When a kid receives one altered (mutated) gene from each parent, a genetic disease may result. An autosomal recessive disorder is typically not present in the parents of a kid who has it.
Describes a property that can only be observed when a genotype is homozygous, a feature that is often concealed by other inherited qualities but survives in a population of heterozygous genotypes.
The crossing between Aa X Aa
Gametes: A and a.
The cross is attached in the image below.
Therefore, the gene's dominant allele, which is expressed when its alleles are distinct, is the case when the alleles are different. The recessive allele effect is hidden by the other allele's effect.
Learn more about recessive, here:
https://brainly.com/question/14340044
#SPJ2