Suppose you a 2 of 10M solution and poured 4 liters of water into it. What would be the new concentration of the solution?

Answer: 10 minutes

Explanation:

ln(No/N) = kt

No = 80 mg

N = 10 mg

t = 30 min

solve for k, then

k = 0.693/t1/2

Substitute k from above and solve for t1/2

10 min is correct.

Answer:

a) both their average kinetic energy and temperature will be the same

Explanation:

Temperature is the measure of the average kinetic energy of a system. As temperature increases, so will kinetic energy. As kinetic energy increases, speed increases. As one decreases, so does the other. When two objects are in contact with each other, their molecules will exchange energy and cause an eventual equilibrium of temperature and kinetic energy.

Answer:

tin

Explanation:

since it takes less heat to change it will warm up and produce thermal energy sooner than carbon

2 kg of carbon at 50°C will provide more thermal energy than 2 kg of tin at the same temperature.

To determine which substance will provide more thermal energy, we need to calculate the thermal energy for both scenarios using the formula:

Thermal energy = mass * specific heat * temperature change

For 2 kg of tin at 50°C:

Thermal energy = 2 kg * 230 J/kg°C * (50°C - 0°C) = 23,000 J

For 2 kg of carbon at 50°C:

Thermal energy = 2 kg * 709 J/kg°C * (50°C - 0°C) = 70,900 J

Therefore, 2 kg of carbon at 50°C will provide more thermal energy than 2 kg of tin at the same temperature. This is because carbon has a higher specific heat (709 J/kg°C) compared to tin (230 J/kg°C), meaning it requires more energy to raise the temperature of carbon compared to tin. As a result, carbon can store and release more thermal energy than tin at the same temperature and mass.

To know more about thermal energy, here

brainly.com/question/3022807

#SPJ2

Answer:

Solve the following problems (assuming constant temperature). Assume all numbers are 3 sig figs. 1. A sample of oxygen gas occupies a volume of 250 mL at 740 torr pressure. ... the gas exert if the volume was decreased to 2.00 liters? ... A 175 mL sample of neon had its pressure changed from 75.0 kPa to 150 kPa.

Explanation:

Answer:

i going to be aniston i would say take a gess

The acidity or alkalinity of a solution depends upon its hydronium ion concentration and hydroxide ion concentration. The concentration of OH⁻ is 1 × 10⁻⁴ M.

The pOH expresses the hydroxide ion concentration of a solution. The pOH of a solution is defined as the negative logarithm to the base 10 of the value of the hydroxide ion concentration in moles per litre.

The equation used to calculate the concentration of OH⁻ is:

pOH = -log [OH⁻]

[OH⁻] = 10⁻pOH

[OH⁻] = 10⁻⁴

= 0.0001 M

The number of significant figures in a reported value is the number of digits that are known with certainty plus the last one having some uncertainty.

Here 0.0001 contains 3 significant figures. In scientific notation it can be represented as 1 × 10⁻⁴ M.

Thus the concentration of [OH⁻] is 1 × 10⁻⁴ M.

To know more about pOH, visit;

https://brainly.com/question/4092108

#SPJ5

Answer:

1. Insulin

2. Keratin

Explanation:

Proteins are one of the four biological molecules found in living systems. They are polymeric molecules made up of monomeric units called AMINO ACIDS. Proteins perform a wide variety of functions in the body ranging from enzymatic functions to structural roles.

Two examples of proteins found in the body are keratin, insulin. Keratin is a structural protein located in the skin, hair and nails while insulin is an enzymatic protein that aids in digestion.

Answer:

CBr4

Explanation:

Answer:

CBr4

Explanation:

It is CBr4 I hope it helps

Answer:

waste water from nuclear power plant is

generally very harmful for our environment

and for everyone

hope it will help

Answer:

It means beside or alongside.

Answer:

The word Paralympics means “parallel with the Olympics”, with the para prefix coming from the Greek word for alongside. The name was chosen to embody the spirit of the two movements existing side-by-side.

Explanation:

Answer:

the answer is D the dominant over powers the resecive traits

Answer:

Mitochondria Is produced by both animal and plant cells

Explanation:

Answer:

When light is shone on to the surface of a metal, its electrons absorb small amounts of energy and become excited into one of its many empty orbitals. The electrons immediately fall back down to lower energy levels and emit light. This process is responsible for the high luster of metals.

Explanation:

Your well-wisher :-)

Answer:

209.4831 g

Explanation:

number of moles × molar mass = mass of substance in g

12.3 × ( 14.0067 + 1.00484 × 3 ) = 209.4831 g

Answer:

The s-, p-, and d-block elements of the periodic table are arranged into 18 numbered columns, or groups. The elements in each group have the same number of valence electrons. As a result, elements in the same group often display similar properties and reactivity.

Explanation:

On the periodic table, a group refers to a vertical column of elements that share similar chemical properties.

For the main groups, the characteristic do the elements have in common is valence electron configuration and chemical reactivity.

On the periodic table, a group refers to a vertical column of elements that share similar chemical properties. These elements are arranged in such a way that they have the same number of valence electrons, which are the electrons in the outermost energy level (shell) of their atoms. The number of valence electrons is a critical factor in determining the chemical behavior and reactivity of elements, as it governs their ability to form chemical bonds with other elements.

Main group elements, also known as representative elements, are located in the s-block and p-block of the periodic table. These elements are found in Groups 1, 2, and 13 to 18. Each main group is labeled with a number from 1 to 18.

Here are the main characteristics that elements in the same main group (vertical column) have in common:

1. Valence Electron Configuration: Elements in the same main group have identical valence electron configurations. For example, elements in Group 1 (alkali metals) all have one valence electron in their outermost energy level (ns¹), while elements in Group 18 (noble gases) have a full outermost energy level.

2. Chemical Reactivity: Due to their identical valence electron configuration, elements in the same group show similar chemical reactivity. They tend to form similar types of chemical bonds and react similarly with other elements to achieve a more stable electron configuration.

3. Periodic Trends: Main group elements within a group exhibit predictable trends in their physical and chemical properties as you move from the top to the bottom of the group. For example, the atomic radius tends to increase, ionization energy tends to decrease, and metallic character tends to increase as you go down a group.

To know more about periodic table here

https://brainly.com/question/28747247

#SPJ2

I cant send this with no text

Have a nice day

Answer:    D

Explanation:

Trust me please

Answer:

V = 0.0496 L

Explanation:

Given that,

The mass of a sample, m = 352.2 g

The density pf sample, d = 7.10 g/mL

We need to find the volume of the sample. We know that the density of an object is given by :

[tex]d=\dfrac{m}{V}\\\\V=\dfrac{m}{d}\\\\V=\dfrac{352.2}{7.1}\\\\V=49.6\ mL[/tex]

or

V = 0.0496 L

So, the volume of the sample is 0.0496 L.

Answer: Image result for What does Boyle's Law describe?

This empirical relation, formulated by the physicist Robert Boyle in 1662, states that the pressure (p) of a given quantity of gas varies inversely with its volume (v) at constant temperature; i.e., in equation form, pv = k, a constant.

Explanation:

Answer:

different , same, same, same

This is a combined gas law problem, according to which

[tex]\frac{P_1V_1}{T_1} = \frac{P_2V_2}{T_2}[/tex]

where P is the pressure of the gas, V is the volume of the gas, and T is the temperature of the gas, and the subscripts 1 and 2 correspond to the initial and final conditions of the gas. In this problem, we are given the initial pressure, volume, and temperature of the gas in the balloon:

P₁ = 1.0 atm

V₁ = 1.8 L

T₁ = 295.15 K (K = °C + 273.15).

Moreover, we are given the final pressure and temperature of the gas in the balloon.

P₂ = 0.86 atm

T₂ = 281.15 K.

What we want to find is the final volume, V₂, which we can obtain by rearranging the combined gas equation to solve for V₂:

[tex]V_2=\frac{P_1V_1T_2}{T_1P_2} = \frac{(1.0 \text{ atm})(1.8 \text{ L})(281.15 \text{ K})}{(295.15 \text{ K})(0.86 \text{ atm})} \\ V_2 = 1.99 \text{ L}[/tex]

This answer has three significant figures. However, the question as written would warrant an answer that comprises one significant figure (as 8 °C has only one sig fig). In that case, the answer would be 2 L. If the answer is to be given to two significant figures, the volume would then be 2.0 L.

Answer:

1.25 moles NaNO

Explanation:

Molarity = moles/Volume (L)

moles = Molarity (M) x Volume (L)

M = 2.5 M

V = 500 mL = 0.5L

moles = M x V = 2.5 x 0.5 = 1.25 moles

Answer:

noe  sory opwqkfj

s

Explanation:

Answer: If we work it out with direct proportions, the vapor pressure of propanone is 56 degrees Celsius. The atmospheric pressure is about 101.

Explanation: hope this helps.

The vapor pressure of propanone at 50°C is :

- 78° vapor pressure

When the vapor pressure is specifically work through the extents to a temperature rate it response is intensely subordinate on their possess a mass nature.

The vapor weight of propanone is calculated and shape in degree Celsius in rate.

The rate of vapor when it is calculated by 50°C with propanone its at long last gives us a 78° vapor pressure.

Learn more about "Propanone":

https://brainly.com/question/491528?referrer=searchResults

Answer:

milk and sugar and vinillia it uses a machine and you stir until it forms

Explanation: