The conversion from meters to astronomical units is done by dividing the average distance by 1. 5 × 10^11.
Just as different areas of human endeavor has different units, the unit of length in astronomy is astronomical units. The astronomical unit is defined as the distance between the center of the earth and the sun.
To solve a problem using the equation for Kepler's third law, Enrico must convert the average distance of Mars from the Sun from meters into astronomical units. This is done by dividing the average distance by 1. 5 × 10^11.
Learn more: https://brainly.com/question/17638582
A piece of iron has a density of 7.86 g/cm3 and a mass of 1.09 x 10^-1 kg. Calculate the volume of the piece of iron.
A group of waves is propagated at a speed that is ________ the speed of the individual waves in deep water.
the free body diagram shown above is for a 5 kg box on a rough surface being pulled to the right at a constant speed by a string that is at an angle of 30° above the horizontal. the coefficient of kinetic friction between the box and the surface is 0.30. the tension in this string is most nearly:
The tension in the string pulling the box is most nearly 17 N.
The given parameters;
mass of the box, m = 5 kginclination of the string, θ = 30°coefficient of kinetic friction, μ = 0.3The tension on the string is calculated by applying Newton's second law of motion as follows.
[tex]\Sigma F = ma[/tex]
at constant speed, acceleration, a, = 0
[tex]\Sigma F = 0\\\\T_x - \mu F_n = 0\\\\Tcos(\theta) - \mu F_n = 0\\\\Tcos(\theta)= \mu F_n\\\\T = \frac{\mu F_n}{cos(\theta)} \\\\T = \frac{0.3 \times 5 \times 9.8}{cos(30)} \\\\T = 16.97 \ N\\\\T \approx 17 \ N[/tex]
Thus, the tension in the string pulling the box is most nearly 17 N.
Learn more here:https://brainly.com/question/21040480
What symbols are these?
Answer:
the bottom one is wollsiegel
What is an energy storage device composed of electrochemical cells?
An energy storage device composed of electrochemical cells is referred to as: battery.
A power source can be defined as a source of electrical energy that is used to power all electronic devices.
Generally, a power source can be classified into two (2) main categories and these include:
Alternating current (AC)Direct current (DC)A battery refers to an energy storage device that comprises electrochemical cells and it serve as a source of direct current (DC). Also, sometimes a battery can be recharged when its electrochemical cells are still active.
Read more on battery here: https://brainly.com/question/4922532
Answer:
Battery is an electrical energy storage device consisting of one or more electrochemical cells with external connections that provide power to electrical devices such as flashlights, smartphones, and electric cars.
Physics Physics Physics - 10
Answer:Pulley , Wheel and axle , Screw , wedge , Incline
Explanation:
Answer: below .
Explanation:
Pulley , Wheel , axle , Screw , wedge , Incline
HOPE IT HELPS YOU .PLEASE GIVE BRAINLIEST .THANKS .
How to solve projectile motion problems with angles.
Answer:
R=v2isin2Big R
=v I 2 sin 2 B I g
Where could light travel the easiest and fastest?
A) through air
B) through empty space
C) through liquid hydrogen
Explanation:
Light travels fastest through air
Answer:
try through air
Explanation:
please help I'm stuck on this question
Answer:
increase
decrease
Explanation:
using formula
Vt=mg/6πηr
so if m increases V increases
r is the denominator so if r increases V decreases
Using Boyle's law, predict what will happen to a balloon that an ocean diver takes to a pressure of 202 kPa.
NO LINKS YA FILTHY VERMINS
Answer:
Balloon that an ocean diver takes to a pressure of 202 k Pa will get reduced in size that is the volume of the balloon will get reduced
Explanation:
I will give 100 Points, 5-stars, and Brainliest
Direct contact is necessary for which type of energy transfer?
A. Conduction
B. Sound Waves
C. Conduction
D. Convection
Answer:
Conduction
Explanation:
Because when a molecule is transferred to another molecule then this in going into direct contact
For example if we have a pan and it is boiling well the heat that is on the pan holder that stays in place and it won`t move anywhere else like there is Radiation and Convection but for this question the answer would be Conduction
Lacie kicks a football from ground level at a velocity of 13.9 m/s and at an angle of 25.0° to the ground. You have determined that the football would travel 15.1 m before landing.
How would this value change if the football was kicked at an angle of 35.0°?Complete all equations without rounding and then round to the nearest tenth at the end.
From edge
Answer:
like 23 or something
Explanation:
6. Explain the importance of the law of conservation of mass.
Answer:
According to the law of conservation of mass, the mass of the products in a chemical reaction must equal the mass of the reactants. The law of conservation of mass is useful for a number of calculations and can be used to solve for unknown masses, such the amount of gas consumed or produced during a reaction.
Explanation:
<3
The ______ of Saturn vary in thickness and are composed of icy chunks ranging in size from sand to boulders (and even larger).
Answer:
"rings" - viewed from a distance, Saturn appears to be surrounded by rings
helpp I'll give brainliest smth
Why there has to be a driving force to keep the car moving at a constant speed?
Explanation:
For example, when a car travels at a constant speed, the driving force from the engine is balanced by resistive forces such as air resistance and friction in the car's moving parts. ... an object falling at terminal velocity experiences the same air resistance as its weight.
Help me quick!!! please!!
Calculate the power of an engine which raises a mass of 1000 kg to a height of 40 m in 10 s.
Answer:
39.240 W
Explanation:
Let's start by calculating the work done by the engine. We can assume that it is the same work done by the weight of the object to bring it from 40m to the surface: as much energy it takes to bring it up, the same ammount it takes to bring it down. Said work is [tex]w= \vec F\cdot \vec{h} = mg h = 1000 \times 9.81\times 40 = 392.400 J[/tex]
At this point we can simply apply the definition of power, that is [tex]P = \frac wt[/tex], to get the power of the engine is [tex]39.240 W[/tex]
Answer:
P=39200W
Explanation:
P=(mgh)/t
P=(40×9.8×1000)/10
P=39200W
When waves are closer together, the distance between them is _________, therefore the waves have __________ wavelength.
Answer:
less' shorter
Explanation:
be cuase science
Answer:
The answer is D.
Explanation:
When waves are closer together, the distance between them is less, therefore the waves have longer wavelength.
Is mixing mixing sugar and cinnamon a chemical or physical change?
Answer:
It is a physical
Explanation:
What would a force diagram for something WHILE it is being thrown DOWNWARDS look like?
Ty
Answer:
it look the same just to tell you
Which two events are part of the rock cycle?
A. Existing rock is melted aboveground and erodes.
B. Existing rock is weathered by water and erodes.
C. Solid rock is heated under high pressure and melts.
D. Solid ice is warmed by sunlight and evaporates.
Answer:
Explanation:
What does negative acceleration mean.
You get in your car after work and turn on the radio. What type of communication does the radio use?.
Answer:
Radio waves
Explanation:
The radio operates by the principles of radio wave.
Electromagnetic wave is a type of wave which does not require material medium for its propagation. A radio wave is an example of electromagnetic wave.
The radio operates in the principle of electromagnetic wave because it does not require material medium for its propagation and it has one of the longest frequency of electromagnetic spectrum.
Thus, we can conclude that the radio operates by the principles of radio wave.
Learn more about radio waves here: https://brainly.com/question/69373
Will give brainliest!
Answer:
chemical symbol
Explanation:
If force F, volume V and density D are taken as fundamental quantities, then the representation of pressure P will be
Using the principle of dimensional analysis, the representation of Pressure would be [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]
Pressure is related to Force, Volume and Density thus :
[tex] Pressure, P = F^{a}V^{b}D^{c}[/tex]
Using dimensional analysis :
Pressure, P = ML¯¹T¯²Substituting the dimension into the relation :
[tex] ML^{-1}T^{-2}= [MLT¯²]^{a} [L³]^{b} [ML¯³]^{c} [/tex]
[tex] ML^{-1}T^{-2} = M^{a+c}L^{a+3b-3c}T^{-2a} [/tex]
Equating the power ;
a + c = 1 - - - (1)
a + 3b - 3c = - 1 - - - (2)
-2a = - 2
a = - 2/-2
a = 1
From (1)
1 + c = 1
c = 1 - 1 = 0
c = 0
From (2) :
1 + 3b - 3(0) = - 1
1 + 3b = - 1
3b = - 2
b = - 2/3
Hence, [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]
Learn more :https://brainly.com/question/25690057
The representation of pressure is:
[tex]P=FV^{-\frac{2}{3} }[/tex]
Given that:
Force F, volume V and density D are taken as fundamental quantities, hence pressure P is:
[tex]P=F^aV^bD^c\\\\(ML^{-1}T^{-2})=(MLT^{-2})^a(L^3)^b(ML^{-3})^c\\\\\\(ML^{-1}T^{-2})=(M)^{a+c}(L)^{a+3b-3c}(T)^{-2a}[/tex]
Hence:-
2 = -2a
a = 1
a + c = 1
1 + c = 1
c = 0
a + 3b - 3c = -1
1 + 3b - 3(0) = -1
3b = -2b = -2/3
Hence the representation of pressure is:
[tex]P=FV^{\frac{-2}{3} }D^{0}\\\\P=FV^{\frac{-2}{3} }[/tex]
Find out more at: https://brainly.com/question/24894056
A girl pushes her little brother on his sled with a force of 300 N for 750 m.
Please find attached photograph for your answer.
Hope it helps.
Do comment if you have any query.
what characteristic of liquids makes them pourbale
Liquids are pourable because they do not maintain a "solid" structure as solids do, but still have structure, unlike gasses. Why is this? The forces between liquid particles are weaker than the forces between solid particles. The particles are further apart and move around more easily.
Have a nice day!
I hope this is what you are looking for, but if not - comment! I will edit and update my answer accordingly. (ノ^∇^)
- Heather
Question 1 of 11
The book has a mass of 2.5 kg.
What net force must act on the book to make it accelerate to the left at a rate
of 7.0 m/s2? (Hint: Use F = ma.)
O A. F = 17.5 N right
OB. F = 2.8 N right
O C. F = 2.8 N left
O D. F = 17.5 N left
Answer:
D. F= 17.5 N left
Explanation:
I just took the quiz and got it correct!
The c-c sigma bond in acetylene is formed by the overlap of which two orbitals.
Answer:When carbon atom tends to form single bonds then its hybridization is , when carbon atom tends to form double bond then its hybridization is and when a carbon atom is attached to a triple bond or with two double bonds then its hydridization is sp.
For example, in HCN molecule there is a triple existing between the carbon and nitrogen atom.
So, hybridization of carbon in this molecules is sp. Moreover, nitrogen atom is also attached via triple bond and it also has a lone pair of electrons. Hence, the hybridization of nitrogen atom is also sp.
Thus, we can conclude that s and p type of orbitals overlap to form the sigma bond between C and N in H−C≡N:
Explanation:
a block weighing (Fg) 500 N is resting on a steel table ( us=0.74) the minimum force start this block moving is?
The minimum force required to start this block moving is 370 N.
The given parameters;
weight of the block, W = 500 Ncoefficient of static friction, [tex]\mu_s[/tex] = 0.74The minimum force required to start this block moving is calculated as follows;
[tex]F= \mu_s F_n[/tex]
where;
[tex]F_n[/tex] is the normal force on the block which is equal to the weight of the block
[tex]F= \mu_s F_n \\\\F= \mu_s W\\\\F = 0.74 \times 500 \\\\F= 370 \ N[/tex]
Thus, the minimum force required to start this block moving is 370 N.
Learn more here: https://brainly.com/question/13877320
2. What are the challenges of wind energy that causes decrease in the electrical production?
3. Give two solutions:
1. Modification in the structure of the turbine
2. Modification in the function of the turbine.
4. You must estimate the cost in each solution, and which one is more affordable and efficient for the municipality to go for.
5. You must make sure that there is minimal energy loss.
Levelized production cost is a big challenge in the production of wind energy.
The main challenge in the production of wind energy is the high production cost. It has to minimize the Levelized Production Cost (LPC) which is the ratio between energy production cost and economic lifetime. This problem can be solved by doing modification in the structure of the turbine as well as we must ensure minimal energy loss.
The modification in the structure can produce more electrical energy and reduce the energy loss also provides more profit to the company so we can conclude that levelized production cost is a big challenge in the production of wind energy.
Learn more: https://brainly.com/question/25543609