nuclear equation of Rn-220 alpha decay

Answer:

Yes, this ring is pure gold because when we divide the mass by the volume we get our density for the ring, which comes out to about 19.32.

Explanation:

Answer:

Triphorphorus Pentanitride

Explanation:

since there are three phosphorus use the prefix tri-, since there are five nitrogen use the prefix penta. tri=3, penta=5. then add a suffix -ide to the end of nitrogen. that will give you triphosphorus pentanitride.

Explanation:

s=2

p=6

d=10

f=14

I hope this was helpful

Answer:

Explanation:

In this problem, we have 50.0 g of solute and 150.0 g of water. The total mass of the solution will thus be 50.0 g + 150.0 g = 200.0 g. The mass percent will be 50.0g/200.0 g (x100%) = 25.0 %.

Mass percent of a solution can be defined as grams of solute per 100 grams of solution.  In this problem, we have 50.0 g of solute and 150.0 g of water.  The total mass of the solution will thus be 50.0 g + 150.0 g = 200.0 g.  The mass percent will be 50.0g/200.0 g (x100%) = 25.0 %.  You can also look at it another way.  Since you have 50 g solute in 200 g solution, you will have 25 g solute in 100 g solution.  By the definition provided above, this is a 25% by mass solution.

Answer: As air is heated its density decreases because its mass remains constant but its volume increases. As air is cooled, its density increases because its mass remains constant but its volume decreases. ... The decrease in density as air is heated causes it to rise above cooler, more dense air. Hope this helped.

Answer:

539.35 g

Explanation:

molar mass of Mg = moles of Ag * molar mass of Ag

x = 5 * 107.87

x = 539.35 g

Answer:

2.408 moles of hydrogen are in the sample.

Explanation:

Molecular formula of acetic acid =CH3COOH

Ratio of carbon to hydrogen :2/4:1/2

Measured  number of moles of carbon atoms = 1.204

Let the moles of hydrogen be = x

Number of carbon atoms in 1.204 mol = 1.204mol*Avogadro number

Number of hydrogen atoms in x mol = x*Avogadro number

As we know that ratio of carbon to hydrogen atoms is 1:2.

1/2=1.204mol* avogadro/ x* avogadro

x = 2.408 moles

2.408 moles of hydrogen are in the sample.

1. The specific heat capacity of the sample of gold obtained is 0.81 J/gºC

2. The substance is not pure gold

The specific heat capacity of the sample of gold can be obtained as follow:

Heat loss = Heat gain

M₉C₉(M₉ –Tₑ) = MᵥᵥC(Tₑ – Tᵥᵥ)

2.74 × C₉(72.1 – 26.3) = 15.2 × 4.184 (26.3 – 24.7)

C₉ × 125.492 = 101.75488

Divide both side by 125.492

C₉ = 101.75488 / 125.492

C₉ = 0.81 J/gºC

From the above we can conclude that the substance is not pure gold since the calculated and standard value of the specific heat capacity of the gold sample is not the same

Learn more about heat transfer:

https://brainly.com/question/6363778

Answer:

Explanation:

Hey there!

From question;

The molecular mass of NH₄OH is 35.

Avogadro number = 6.023*10²³ molecules.

Then,

From mole concept,

Molecular mass =  Avogadro number

So, 35 grams contains  6.023*10²³ molecules.

1 gram contains [tex]\frac{ 6.023*10^{23} }{35}[/tex] molecules.

52.1 grams contains [tex]\frac{6.023*10^{23} }{35} *52.1[/tex] molecules.

Therefore, 52.1 grams contains 8.96*10²³ molecules.

Hope it helps!

Answer:

9.033 × 10²³ molec C₂HF₃O₂ x (2 O atoms / 1 molec C₂HF₃O₂) = 1.8066 x 10²⁴ O atoms

There are 3.01 × 10^23 atoms of oxygen in 1.51×10^23 molecules of trifluoroacetic acid, C2HF3O2.

The formula of trifluoroacetic acid is C2HF3O2

Number of moles of the trifluoroacetic acid(C2HF3O2)is given using the approach;

1 mole of the compound contains 6.02 × 10^23 molecules

x moles of the compound contains 1.51 × 10^23 molecules

x = 1.51 × 10^23 molecules × 1 mole /6.02 × 10^23 molecules

x = 0.25 moles of  trifluoroacetic acid.

Now;

Number of O atoms in the sample = 0.25 × 2 × NA

Where; NA = Avogadro's number

Number of O atoms in the sample = 0.25 × 2 × 6.02 × 10^23 atoms

= 3.01 × 10^23 atoms

Learn more: https://brainly.com/question/24798986

elements increase in reactivity as they go down in groups and up in periods!!

Answer:

Allotrope of carbon.

High melting point.

Explanation:

Answer:

Density lower than that of diamond.

It has soft, slippery feel.

Answer:

The increase in kinetic energy that comes with higher temperatures allows the solvent molecules to more effectively break apart the solute molecules that are held together by intermolecular attractions.

Explanation:

Solubility is affected by temperature due to heatness.

Answer:

0.02moles

Explanation:

To answer this question, the general gas law equation is used. The General gas law is:

Pv = nRT

Where; P = standard atmospheric pressure (1 atm)

V = volume (L)

n = number of moles

R = Gas law constant

T = Temperature

For this question; volume = 1.00L, atmospheric pressure (P) = 1 atm, R = 0.0821 L-atm / mol K, T = 600K, n = ?

Therefore; Pv = nRT

n = PV/RT

n = 1 × 1/ 0.0821 × 600

n = 1/49.26

n = 0.0203moles

Hence, there are 0.02 moles of gas.

The number of mole of the gas present in the cylinder is 0.02 mole

From the question given above, the following data were:

Temperature (T) = 600 K

Volume (V) = 1 L

Pressure (P) = 1 atm

The number of mole of the gas present in the cylinder can be obtained by using the ideal gas equation (PV = nRT) as illustrated below:

Temperature (T) = 600 K

Volume (V) = 1 L

Pressure (P) = 1 atm

Gas constant (R) = 0.0821 atm.L/Kmol

1 × 1 = n × 0.0821 × 600

1 = n × 49.26

Divide both side by 49.26

[tex]n = \frac{1}{49.26}\\\\[/tex]

Thus, 0.02 mole of the gas is present in the cylinder.

Learn more: https://brainly.com/question/12393538

Answer:

d) It incorrectly describes the two processes

Hope it helps you

And please mark it as the brainliest answer

Answer:is 15.2%

Explanation:

Got it wrong and this the correct answer it told me

The percentage of water in the original sample is 15.2 %.

From the information provided in the question;

Weight of the wet sample = 5.00g

Weight of the dried sample = 4.24g

Loss in mass =  5.00g - 4.24g = 0.76 g

percentage of water in the original sample = Difference in mass between wet and dry sample/ mass of wet sample × 100/1

Hence, when we substitute values;

percentage of water in the original sample =  0.76 g/5.00g × 100/1

percentage of water in the original sample = 15.2 %

So, the percentage of water in the original sample is 15.2 %.

Learn more: https://brainly.com/question/14102587

Answer:

indeed it 1s22s22p63523p645230104p5 is bromine

This indicates that in the compound QT the bond is principally ionic in character. It is a fundamental type of chemical bond.

An ionic bond is a type of chemical bond between two atoms due to the attraction between two opposite ions.

These opposite ions in an ionic bonding are referred to as negative ions and positive ions.

An ionic bonding only occurs when the electrons (e-) of a given atom can be transferred to other atoms in the compound.

Learn more about ionic bonds here:

https://brainly.com/question/13526463

Answer:

NO3-

Explanation:

edge2020

no3-Edg 2020

Explanation

Brainliest

TRUE  CO(OH)₂ will precipitate from the solution if the pH of a 0.020 M solution of CO(NO₃)₂ is adjusted. ; ( TRUE )

Given that:

Ksp of CO(OH)₂ =  1.3 * 10⁻¹⁵

Chemical reaction

CO⁺² + 2OH  ---->  CO(OH)₂

First step : determine the pOH value

pOH of solution = 14 - pH

                          = 14 - 8.5 = 5.5

Also

pOH = - log [ OH⁻ ] = 5.5

Therefore :  [OH⁻] = - Antilog ( 5.5 )

                              = 3.16 * 10⁻⁶

[CO⁺²] = 0.02 given that it is obtained from 0.02 M solution of cobalt nitrate

Next step : determine the Ionic product of cobalt hydroxide

Ionic Product ( IP ) = [CO⁺²] [OH⁻]²

                              = 0.02 * ( 3.16 * 10⁻⁶)²

                              = 1.99 * 10⁻¹¹

Given that the Ionic product is greater than the Ksp of CO(OH)₂ therefore CO(OH)₂ will precipitate

Hence we can conclude that TRUE  CO(OH)₂ will precipitate from the solution if the pH of a 0.020 M solution of CO(NO₃)₂ is adjusted. ; ( TRUE )

Learn more about Ionic product : https://brainly.com/question/11638999

Answer: Chemistry is the properties, composition, and structure of elements and compounds, how they can change, and the energy that is released or absorbed when they change.

Explanation:

Answer:

The scientific study of the structure of substances and what happens to them in different conditions or when mixed with each other is known as Chemistry.

Answer:

no

Explanation:

Weight is a measure of how much gravity pulls on a mass or object. On the moon, there is less gravity pulling on objects, so they weigh less. ... But does its mass changejust because it is on the moon? No, it is still the same size and looks the same, it just has less gravity pulling on it, so it weighs less.

Each element is given its own chemical symbol, like H for hydrogen or O for oxygen. Chemical symbols are usually one or two letters long. Every chemical symbol starts with a capital letter, with the second letter written in lower case. For example, Mg is the correct symbol for magnesium, but mg, mG and MG are wrong...

Pls follow me and have a nice day.. ❤️

Answer:

6

Explanation:

slope= [tex]\frac{rise}{run}[/tex]

slope=[tex]\frac{6}{1}[/tex]

slope=6

Answer:

its one half

Explanation:

i learned this last week

Histidine, an essential amino acid, has as a positively charged imidazole functional group. The imidazole makes it a common participant in enzyme catalyzed reactions. The unprotonated imidazole is nucleophilic and can serve as a general base, while the protonated form can serve as a general acid.

Answer:

Explanation:

The protein comprises of two 60-kD polypeptides and two 40-kD polypeptides. Each one of the 40-kD chains has a disulfide-bond which is directly bonded to a 60-kD chain.

The 100-kD units attach noncovalently to produce a protein with a molecular mass of 200 kD. The interaction among the different subunits in the protein is not affected by the Gel filtration chromatography.

Hence, the protein seems to be 200 kD in size. When SDS-PAGE takes place samples are being subjected to heat and therefore undergoing denaturation conditions. The aftermath effect of this causes disorganization in the 100 kD units.

However, the reducing agent (BME) main task is the reduction of disulfide bonds in a protein.

It implies that BME is responsible for the reduction between the R1-S-S-R2 bond between 40 kD and 60 kD to R1-SH and R2-SH, resulting in seperate proteins.

Answer:

62.1 gram

Explanation:

Al molar mass = 27 g/mol

mass = molar mass × no of moles

= 27 × 2.3 = 62.1 gram

Answer:

They experiment, and study

Explanation:

Repeat your experiments several times to make sure that the first results weren't just an accident.

Answer:

Your question will be shared anonymously with online publishers who may be interested in answering it

Explanation:

make me as brain